Review the questions below alongside the page information. Keep the original part reference, agreed specification and any project-specific requirements with your inquiry.
No. Identify the specific gantry or other assembly, the contact position and the OEM part number. Confirm the transfer function and contact design in the equipment documentation. Do not assume that every scanner interface uses the same kind of brush.
Provide the scanner model and hardware revision, assembly drawing and original contact reference. Include the approved material, contact geometry, holder arrangement and applicable validation requirements. Keep the enquiry within the scanner maker's authorized service and parts process.
No. Dimensional fit alone does not establish electrical behaviour, wear, interference or imaging performance in the installed system. The OEM and authorized service team must define and complete the required acceptance checks for the specific replacement.
No. Use the scanner maker's instructions for the component's actual location and exposure. Any required chemical-compatibility evidence must concern the specified material and assembly. Do not apply a general hospital-cleaning claim to an internal gantry contact.
No. The authorized service provider should diagnose the system and carry out the OEM-required validation before clinical release. This page does not prescribe scanner repairs or promise that changing a contact will remove an image artifact or mechanical noise.
Provide the scanner and assembly revision, approved contact reference and controlled drawing. State the quantity and required acceptance documentation. The OEM-authorized project or service team should review any hardware or component change before an earlier supply specification is reused.